Re: [PATCH v3 2/2] media: qcom: camss: Enable the streams API on SC7280

["Gjorgji Rosikopulos (Consultant)" <gjorgji.rosikopulos@oss.qualcomm.com>]

Hi Hitesh,

On 10/12/2026 12:23 PM, Hitesh Patel wrote:
> On 12/10/2026 10:27, Gjorgji Rosikopulos (Consultant) wrote:
>> Thanks i will try to include your changes in my next series,
>> it will need verification from your side as well.
> 
> Please do carry it in v2 - that is the right way round, since the patch
> does not build without your series and there is no point in it going
> separately.
> 
> Two things to make v2 easier:
> 
> 1) streams_enable at SoC level, per Bryan's comment. struct camss_resources
>    already has legacy_phy set once per SoC, so putting streams_enable
>    next to it keeps the two consistent and drops the 15 per-subdev
>    assignments my patch was adding. Happy to prepare that hunk if useful.
> 
> 2) The CSIPHY legacy-PHY conflict Bryan reported on 1/8 yesterday. I
>    already resolved that when porting to qcom-next v7.2; details in my
>    reply on that thread. Reusing it should let v2 apply to current
>    linux-next without you needing the hardware to test the legacy path.

Thanks please share what you have done it will make my life easier,
I will include all your changes in v2 patchset.

> 
> The SER/DES setup is up and running here, so send v2 whenever it is ready
> and I will verify on RB3 Gen2 (QCS6490 / SC7280) with two GMSL cameras
> behind a MAX9296A, one per CSI-2 port. I will run it against current
> linux-next rather than our vendor branch this time, so the Tested-by
> applies to the tree you are actually submitting against.

Thanks that is noted.

~Gjorgji