Re: [PATCH v5 3/6] drm/msm/dpu: enable compression bit in cfg2 for DSC

[Jessica Zhang <quic_jesszhan@quicinc.com>]

On 5/27/2024 7:21 AM, Jun Nie wrote:
> Enable compression bit in cfg2 register for DSC in the DSI case
> 
> Signed-off-by: Jun Nie <jun.nie@linaro.org>
> ---
>   drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c | 4 ++++
>   1 file changed, 4 insertions(+)
> 
> diff --git a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
> index f97221423249..34bfcfba3df2 100644
> --- a/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
> +++ b/drivers/gpu/drm/msm/disp/dpu1/dpu_hw_intf.c
> @@ -177,6 +177,10 @@ static void dpu_hw_intf_setup_timing_engine(struct dpu_hw_intf *intf,
>   	if (p->wide_bus_en && !dp_intf)
>   		data_width = p->width >> 1;
>   
> +	/* TODO: handle DSC+DP case, we only handle DSC+DSI case so far */
> +	if (p->compression_en && !dp_intf)
> +		intf_cfg2 |= INTF_CFG2_DCE_DATA_COMPRESS;

Hi Jun,

The DSC/DCE enablement registers were only moved to INTF in DPU 7.x and 
later.

We should probably add some MDSS version check similar to what command 
mode INTF does here [1]

Thanks,

Jessica Zhang

> +
>   	hsync_data_start_x = hsync_start_x;
>   	hsync_data_end_x =  hsync_start_x + data_width - 1;
>   
> 
> -- 
> 2.34.1
>