Re: [PATCH] ASoC: tlv320adcx140: Add controls for PDM clk and edge

[Dan Murphy <dmurphy@ti.com>]

Mark

On 5/13/20 10:32 AM, Mark Brown wrote:
> On Wed, May 13, 2020 at 09:47:46AM -0500, Dan Murphy wrote:
>
>> +static const char * const pdmclk_text[] = {
>> +	"2.8224 MHz", "1.4112 MHz", "705.6 kHz", "5.6448 MHz"
>> +};
>> +
>> +static SOC_ENUM_SINGLE_DECL(pdmclk_select_enum, ADCX140_PDMCLK_CFG, 0,
>> +			    pdmclk_text);
>> +
>> +static const struct snd_kcontrol_new pdmclk_div_controls[] = {
>> +	SOC_DAPM_ENUM("PDM Clk Divider Select", pdmclk_select_enum),
>> +};
>> +
>> +static const char * const pdm_edge_text[] = {
>> +	"Negative", "Positive"
>> +};
> Are these (especially the clock and polarity) things that are going to
> vary at runtime?  I'd have expected these to come from the hardware
> rather than being something that could usefully change.
Some microphone support low power modes that use a slower clock.
Polarity will probably not change at run-time, but clock speed can 
change to move mics from low power/low-resolution to higher 
power/high-resolution mode.

So polarity can be made hardware specific but clocks should be configurable.

I can break these out into separate patches if you want.

Dan