mirror of https://lore.kernel.org/lkml/
 help / color / mirror / Atom feed
From: "Haar János" <djani22@netcenter.hu>
To: "Andrew Moise" <chops@demiurgestudios.com>
Cc: <linux-kernel@vger.kernel.org>
Subject: Re: DMA errors, then I/O errors, on 2.6.16
Date: Sat, 27 May 2006 23:18:47 +0200	[thread overview]
Message-ID: <02c701c681d3$2a17e750$1800a8c0@dcccs> (raw)
In-Reply-To: <20060527210715.GA2866@qix.demiurgestudios.com>

Hi!

I am just a single user, but i have get this too earlier.

If it is a WD hdd, try to use master AND slave on the same cable, or try to
set "cable select" setting on hdd!

This works for me! ;-)

(Only WD made this for me, and only when it is a single master drive.)

Cheers,

Janos
----- Original Message ----- 
From: "Andrew Moise" <chops@demiurgestudios.com>
To: <linux-kernel@vger.kernel.org>
Sent: Saturday, May 27, 2006 11:07 PM
Subject: DMA errors, then I/O errors, on 2.6.16


>   Running 2.6.16 (and some earlier 2.6 kernels as well), I get
> occasional DMA failures, which are always followed by the disk not
> working at all (any request leads to an I/O error).  The log and whatnot
> follows.  Can anyone tell me what the source of this trouble might be
> (disk, controller, cable, software)?
>   Please CC replies to me, as I'm not on the list.  Thanks.
>
> --- Log:
>
> May 27 16:34:44 vino kernel: hda: dma_intr: status=0x7f { DriveReady
DeviceFault
>  SeekComplete DataRequest CorrectedError Index Error }
> May 27 16:34:44 vino kernel: hda: dma_intr: error=0x7f { DriveStatusError
UncorrectableError SectorIdNotFound TrackZeroNotFound AddrMarkNotFound },
LBAsect=1495
> 68083689343, high=8914952, low=8355711, sector=356876123
> May 27 16:34:44 vino kernel: ide: failed opcode was: unknown
> May 27 16:34:44 vino kernel: hda: DMA disabled
> May 27 16:34:44 vino kernel: ide0: reset: master: error (0x0a?)
> May 27 16:34:44 vino kernel: hda: task_in_intr: status=0x7f { DriveReady
DeviceFault SeekComplete DataRequest CorrectedError Index Error }
> May 27 16:34:44 vino kernel: hda: task_in_intr: error=0x7f {
DriveStatusError UncorrectableError SectorIdNotFound TrackZeroNotFound
AddrMarkNotFound }, LBAsect=
> 149568083689343, high=8914952, low=8355711, sector=356876123
> May 27 16:34:44 vino kernel: ide: failed opcode was: unknown
> May 27 16:34:44 vino kernel: ide0: reset: master: error (0x0a?)
> May 27 16:34:44 vino kernel: end_request: I/O error, dev hda, sector
356876123
> May 27 16:34:44 vino kernel: end_request: I/O error, dev hda, sector
356876131
>
>   ... and so on, for many more I/O errors.
>
> --- Version:
>
> Linux version 2.6.16-1-486 (Debian 2.6.16-12) (waldi@debian.org) (gcc
version 4.0.4 20060422 (prerelease) (Debian 4.0.3-2)) #2 Thu May 4 18:15:54
UTC 2006
>
> --- Disk controller:
>
> 0000:00:11.1 IDE interface: VIA Technologies, Inc.
VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a
[Master SecP PriP])
>         Subsystem: VIA Technologies, Inc.: Unknown device aa01
>         Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
>         Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
>         Latency: 32
>         Interrupt: pin A routed to IRQ 11
>         Region 4: I/O ports at e000 [size=16]
>         Capabilities: [c0] Power Management version 2
>                 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
>                 Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/


  reply	other threads:[~2006-05-27 21:19 UTC|newest]

Thread overview: 5+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2006-05-27 21:07 Andrew Moise
2006-05-27 21:18 ` Haar János [this message]
2006-05-27 21:54   ` Andrew Moise
2006-05-27 21:20 ` Valdis.Kletnieks
2006-05-28  8:33 ` Arjan van de Ven

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to='02c701c681d3$2a17e750$1800a8c0@dcccs' \
    --to=djani22@netcenter.hu \
    --cc=chops@demiurgestudios.com \
    --cc=linux-kernel@vger.kernel.org \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox

all inboxes | Powered by JetHome®