DMA errors, then I/O errors, on 2.6.16

DMA errors, then I/O errors, on 2.6.16

[Andrew Moise]

  Running 2.6.16 (and some earlier 2.6 kernels as well), I get
occasional DMA failures, which are always followed by the disk not
working at all (any request leads to an I/O error).  The log and whatnot
follows.  Can anyone tell me what the source of this trouble might be
(disk, controller, cable, software)?
  Please CC replies to me, as I'm not on the list.  Thanks.

--- Log:

May 27 16:34:44 vino kernel: hda: dma_intr: status=0x7f { DriveReady DeviceFault
 SeekComplete DataRequest CorrectedError Index Error } 
May 27 16:34:44 vino kernel: hda: dma_intr: error=0x7f { DriveStatusError UncorrectableError SectorIdNotFound TrackZeroNotFound AddrMarkNotFound }, LBAsect=1495
68083689343, high=8914952, low=8355711, sector=356876123 
May 27 16:34:44 vino kernel: ide: failed opcode was: unknown 
May 27 16:34:44 vino kernel: hda: DMA disabled 
May 27 16:34:44 vino kernel: ide0: reset: master: error (0x0a?) 
May 27 16:34:44 vino kernel: hda: task_in_intr: status=0x7f { DriveReady DeviceFault SeekComplete DataRequest CorrectedError Index Error } 
May 27 16:34:44 vino kernel: hda: task_in_intr: error=0x7f { DriveStatusError UncorrectableError SectorIdNotFound TrackZeroNotFound AddrMarkNotFound }, LBAsect=
149568083689343, high=8914952, low=8355711, sector=356876123 
May 27 16:34:44 vino kernel: ide: failed opcode was: unknown 
May 27 16:34:44 vino kernel: ide0: reset: master: error (0x0a?) 
May 27 16:34:44 vino kernel: end_request: I/O error, dev hda, sector 356876123 
May 27 16:34:44 vino kernel: end_request: I/O error, dev hda, sector 356876131 

  ... and so on, for many more I/O errors.

--- Version:

Linux version 2.6.16-1-486 (Debian 2.6.16-12) (waldi@debian.org) (gcc version 4.0.4 20060422 (prerelease) (Debian 4.0.3-2)) #2 Thu May 4 18:15:54 UTC 2006

--- Disk controller:

0000:00:11.1 IDE interface: VIA Technologies, Inc.  VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a [Master SecP PriP])
        Subsystem: VIA Technologies, Inc.: Unknown device aa01
        Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
        Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
        Latency: 32
        Interrupt: pin A routed to IRQ 11
        Region 4: I/O ports at e000 [size=16]
        Capabilities: [c0] Power Management version 2
                Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA PME(D0-,D1-,D2-,D3hot-,D3cold-)
                Status: D0 PME-Enable- DSel=0 DScale=0 PME-

Re: DMA errors, then I/O errors, on 2.6.16

[Haar János]

Hi!

I am just a single user, but i have get this too earlier.

If it is a WD hdd, try to use master AND slave on the same cable, or try to
set "cable select" setting on hdd!

This works for me! ;-)

(Only WD made this for me, and only when it is a single master drive.)

Cheers,

Janos
----- Original Message ----- 
From: "Andrew Moise" <chops@demiurgestudios.com>
To: <linux-kernel@vger.kernel.org>
Sent: Saturday, May 27, 2006 11:07 PM
Subject: DMA errors, then I/O errors, on 2.6.16


>   Running 2.6.16 (and some earlier 2.6 kernels as well), I get
> occasional DMA failures, which are always followed by the disk not
> working at all (any request leads to an I/O error).  The log and whatnot
> follows.  Can anyone tell me what the source of this trouble might be
> (disk, controller, cable, software)?
>   Please CC replies to me, as I'm not on the list.  Thanks.
>
> --- Log:
>
> May 27 16:34:44 vino kernel: hda: dma_intr: status=0x7f { DriveReady
DeviceFault
>  SeekComplete DataRequest CorrectedError Index Error }
> May 27 16:34:44 vino kernel: hda: dma_intr: error=0x7f { DriveStatusError
UncorrectableError SectorIdNotFound TrackZeroNotFound AddrMarkNotFound },
LBAsect=1495
> 68083689343, high=8914952, low=8355711, sector=356876123
> May 27 16:34:44 vino kernel: ide: failed opcode was: unknown
> May 27 16:34:44 vino kernel: hda: DMA disabled
> May 27 16:34:44 vino kernel: ide0: reset: master: error (0x0a?)
> May 27 16:34:44 vino kernel: hda: task_in_intr: status=0x7f { DriveReady
DeviceFault SeekComplete DataRequest CorrectedError Index Error }
> May 27 16:34:44 vino kernel: hda: task_in_intr: error=0x7f {
DriveStatusError UncorrectableError SectorIdNotFound TrackZeroNotFound
AddrMarkNotFound }, LBAsect=
> 149568083689343, high=8914952, low=8355711, sector=356876123
> May 27 16:34:44 vino kernel: ide: failed opcode was: unknown
> May 27 16:34:44 vino kernel: ide0: reset: master: error (0x0a?)
> May 27 16:34:44 vino kernel: end_request: I/O error, dev hda, sector
356876123
> May 27 16:34:44 vino kernel: end_request: I/O error, dev hda, sector
356876131
>
>   ... and so on, for many more I/O errors.
>
> --- Version:
>
> Linux version 2.6.16-1-486 (Debian 2.6.16-12) (waldi@debian.org) (gcc
version 4.0.4 20060422 (prerelease) (Debian 4.0.3-2)) #2 Thu May 4 18:15:54
UTC 2006
>
> --- Disk controller:
>
> 0000:00:11.1 IDE interface: VIA Technologies, Inc.
VT82C586A/B/VT82C686/A/B/VT823x/A/C PIPC Bus Master IDE (rev 06) (prog-if 8a
[Master SecP PriP])
>         Subsystem: VIA Technologies, Inc.: Unknown device aa01
>         Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
ParErr- Stepping- SERR- FastB2B-
>         Status: Cap+ 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
>         Latency: 32
>         Interrupt: pin A routed to IRQ 11
>         Region 4: I/O ports at e000 [size=16]
>         Capabilities: [c0] Power Management version 2
>                 Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
PME(D0-,D1-,D2-,D3hot-,D3cold-)
>                 Status: D0 PME-Enable- DSel=0 DScale=0 PME-
>
> -
> To unsubscribe from this list: send the line "unsubscribe linux-kernel" in
> the body of a message to majordomo@vger.kernel.org
> More majordomo info at  http://vger.kernel.org/majordomo-info.html
> Please read the FAQ at  http://www.tux.org/lkml/

Re: DMA errors, then I/O errors, on 2.6.16

[Andrew Moise]

On Sat, May 27, 2006 at 11:18:47PM +0200, Haar János wrote:
> If it is a WD hdd, try to use master AND slave on the same cable, or try to
> set "cable select" setting on hdd!

  Sadly, it's a Maxtor drive, already set to cable select.  When I
opened the case to check the jumper, I noticed that the drive is very
hot; I tried improving the airflow to see if it's caused by the drive
overheating.

Re: DMA errors, then I/O errors, on 2.6.16

[Valdis.Kletnieks]

[-- Attachment #1: Type: text/plain, Size: 429 bytes --]

On Sat, 27 May 2006 17:07:15 EDT, Andrew Moise said:
>   Running 2.6.16 (and some earlier 2.6 kernels as well), I get
> occasional DMA failures, which are always followed by the disk not
> working at all (any request leads to an I/O error).

Have you tried running 'badblocks /dev/hda' under a kernel that is
believe to be working?  That looks more like a drive trying to fail
due to hardware causes than a software problem.....

[-- Attachment #2: Type: application/pgp-signature, Size: 226 bytes --]

Re: DMA errors, then I/O errors, on 2.6.16

[Arjan van de Ven]

On Sat, 2006-05-27 at 17:07 -0400, Andrew Moise wrote:
>   Running 2.6.16 (and some earlier 2.6 kernels as well), I get
> occasional DMA failures, which are always followed by the disk not
> working at all (any request leads to an I/O error).  The log and whatnot
> follows.  Can anyone tell me what the source of this trouble might be
> (disk, controller, cable, software)?
>   Please CC replies to me, as I'm not on the list.  Thanks.
> 
> --- Log:
> 
> May 27 16:34:44 vino kernel: hda: dma_intr: status=0x7f { DriveReady DeviceFault
>  SeekComplete DataRequest CorrectedError Index Error } 
> May 27 16:34:44 vino kernel: hda: dma_intr: error=0x7f { DriveStatusError UncorrectableError SectorIdNotFound TrackZeroNotFound AddrMarkNotFound }, LBAsect=1495
> 68083689343, high=8914952, low=8355711, sector=356876123 


this tends to be a disk dying.. better run smartctl to check it out...