From: Jamie Iles <jamie@jamieiles.com>
To: linux-kernel@vger.kernel.org
Cc: linux@arm.linux.org.uk, tglx@linutronix.de,
cbouatmailru@gmail.com, grant.likely@secretlab.ca, arnd@arndb.de,
nico@fluxnic.net, Jamie Iles <jamie@jamieiles.com>
Subject: [PATCHv2 7/7] basic_mmio_gpio: support direction registers
Date: Fri, 8 Apr 2011 15:16:51 +0100 [thread overview]
Message-ID: <1302272211-30242-8-git-send-email-jamie@jamieiles.com> (raw)
In-Reply-To: <1302272211-30242-1-git-send-email-jamie@jamieiles.com>
Most controllers require the direction of a GPIO to be set by writing to
a direction register. Add support for either an input direction
register or an output direction register.
Signed-off-by: Jamie Iles <jamie@jamieiles.com>
Acked-by: Anton Vorontsov <cbouatmailru@gmail.com>
Cc: Grant Likely <grant.likely@secretlab.ca>
---
drivers/gpio/basic_mmio_gpio.c | 102 +++++++++++++++++++++++++++++++++++++++-
1 files changed, 100 insertions(+), 2 deletions(-)
diff --git a/drivers/gpio/basic_mmio_gpio.c b/drivers/gpio/basic_mmio_gpio.c
index ed4b0c6..9e0157a 100644
--- a/drivers/gpio/basic_mmio_gpio.c
+++ b/drivers/gpio/basic_mmio_gpio.c
@@ -71,6 +71,7 @@ struct bgpio_chip {
void __iomem *reg_set;
void __iomem *reg_clr;
void __iomem *reg_in;
+ void __iomem *reg_dir;
/* Number of bits (GPIOs): <register width> * 8. */
int bits;
@@ -89,6 +90,9 @@ struct bgpio_chip {
/* Shadowed data register to clear/set bits safely. */
unsigned long data;
+
+ /* Shadowed direction registers to clear/set direction safely. */
+ unsigned long dir;
};
static struct bgpio_chip *to_bgpio_chip(struct gpio_chip *gc)
@@ -193,15 +197,72 @@ static void bgpio_set_with_clear(struct gpio_chip *gc, unsigned int gpio,
bgc->write_reg(bgc->reg_clr, mask);
}
+static int bgpio_simple_dir_in(struct gpio_chip *gc, unsigned int gpio)
+{
+ return 0;
+}
+
+static int bgpio_simple_dir_out(struct gpio_chip *gc, unsigned int gpio,
+ int val)
+{
+ gc->set(gc, gpio, val);
+
+ return 0;
+}
+
static int bgpio_dir_in(struct gpio_chip *gc, unsigned int gpio)
{
+ struct bgpio_chip *bgc = to_bgpio_chip(gc);
+ unsigned long flags;
+
+ spin_lock_irqsave(&bgc->lock, flags);
+ bgc->dir &= ~bgc->pin2mask(bgc, gpio);
+ bgc->write_reg(bgc->reg_dir, bgc->dir);
+ spin_unlock_irqrestore(&bgc->lock, flags);
+
return 0;
}
static int bgpio_dir_out(struct gpio_chip *gc, unsigned int gpio, int val)
{
+ struct bgpio_chip *bgc = to_bgpio_chip(gc);
+ unsigned long flags;
+
+ gc->set(gc, gpio, val);
+
+ spin_lock_irqsave(&bgc->lock, flags);
+ bgc->dir |= bgc->pin2mask(bgc, gpio);
+ bgc->write_reg(bgc->reg_dir, bgc->dir);
+ spin_unlock_irqrestore(&bgc->lock, flags);
+
+ return 0;
+}
+
+static int bgpio_dir_in_inv(struct gpio_chip *gc, unsigned int gpio)
+{
+ struct bgpio_chip *bgc = to_bgpio_chip(gc);
+ unsigned long flags;
+
+ spin_lock_irqsave(&bgc->lock, flags);
+ bgc->dir |= bgc->pin2mask(bgc, gpio);
+ bgc->write_reg(bgc->reg_dir, bgc->dir);
+ spin_unlock_irqrestore(&bgc->lock, flags);
+
+ return 0;
+}
+
+static int bgpio_dir_out_inv(struct gpio_chip *gc, unsigned int gpio, int val)
+{
+ struct bgpio_chip *bgc = to_bgpio_chip(gc);
+ unsigned long flags;
+
gc->set(gc, gpio, val);
+ spin_lock_irqsave(&bgc->lock, flags);
+ bgc->dir &= ~bgc->pin2mask(bgc, gpio);
+ bgc->write_reg(bgc->reg_dir, bgc->dir);
+ spin_unlock_irqrestore(&bgc->lock, flags);
+
return 0;
}
@@ -268,6 +329,13 @@ static int bgpio_setup_accessors(struct platform_device *pdev,
* - single output/input register resource (named "dat").
* - separate output/input register resources (named "dat" and "in").
*
+ * For setting the GPIO direction, there are three supported configurations:
+ *
+ * - simple bidirection GPIO that requires no configuration.
+ * - an output direction register (named "dirout") where a 1 bit
+ * indicates the GPIO is an output.
+ * - an input direction register (named "dirin") where a 1 bit indicates
+ * the GPIO is an input.
*/
static int bgpio_setup_io(struct platform_device *pdev,
struct bgpio_chip *bgc)
@@ -308,6 +376,34 @@ static int bgpio_setup_io(struct platform_device *pdev,
return 0;
}
+static int bgpio_setup_direction(struct platform_device *pdev,
+ struct bgpio_chip *bgc)
+{
+ struct resource *res_dirout;
+ struct resource *res_dirin;
+
+ res_dirout = platform_get_resource_byname(pdev, IORESOURCE_MEM,
+ "dirout");
+ res_dirin = platform_get_resource_byname(pdev, IORESOURCE_MEM, "dirin");
+ if (res_dirout && res_dirin) {
+ return -EINVAL;
+ } else if (res_dirout) {
+ bgc->reg_dir = bgpio_request_and_map(&pdev->dev, res_dirout);
+ if (!bgc->reg_dir)
+ return -ENOMEM;
+ bgc->gc.direction_output = bgpio_dir_out;
+ bgc->gc.direction_input = bgpio_dir_in;
+ } else if (res_dirin) {
+ bgc->reg_dir = bgpio_request_and_map(&pdev->dev, res_dirin);
+ if (!bgc->reg_dir)
+ return -ENOMEM;
+ bgc->gc.direction_output = bgpio_dir_out_inv;
+ bgc->gc.direction_input = bgpio_dir_in_inv;
+ } else {
+ bgc->gc.direction_output = bgpio_simple_dir_out;
+ bgc->gc.direction_input = bgpio_simple_dir_in;
+ }
+
return 0;
}
@@ -361,11 +457,13 @@ static int __devinit bgpio_probe(struct platform_device *pdev)
return ret;
spin_lock_init(&bgc->lock);
+ ret = bgpio_setup_direction(pdev, bgc);
+ if (ret)
+ return ret;
+
bgc->data = bgc->read_reg(bgc->reg_dat);
bgc->gc.ngpio = ngpio;
- bgc->gc.direction_input = bgpio_dir_in;
- bgc->gc.direction_output = bgpio_dir_out;
bgc->gc.dev = dev;
bgc->gc.label = dev_name(dev);
--
1.7.4.2
next prev parent reply other threads:[~2011-04-08 14:17 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2011-04-08 14:16 [PATCHv2 0/7] gpio: extend basic_mmio_gpio for different controllers Jamie Iles
2011-04-08 14:16 ` [PATCHv2 1/7] basic_mmio_gpio: remove runtime width/endianness evaluation Jamie Iles
2011-04-08 14:16 ` [PATCHv2 2/7] basic_mmio_gpio: convert to platform_{get,set}_drvdata() Jamie Iles
2011-04-08 14:16 ` [PATCHv2 3/7] basic_mmio_gpio: allow overriding number of gpio Jamie Iles
2011-04-08 14:16 ` [PATCHv2 4/7] basic_mmio_gpio: request register regions Jamie Iles
2011-04-08 14:16 ` [PATCHv2 5/7] basic_mmio_gpio: detect output method at probe time Jamie Iles
2011-04-08 14:16 ` [PATCHv2 6/7] basic_mmio_gpio: support different input/output registers Jamie Iles
2011-04-08 14:36 ` Anton Vorontsov
2011-04-08 14:40 ` Jamie Iles
2011-04-08 14:46 ` Anton Vorontsov
2011-04-08 16:11 ` Jamie Iles
2011-04-08 16:26 ` Anton Vorontsov
2011-04-08 16:32 ` Jamie Iles
2011-04-08 14:16 ` Jamie Iles [this message]
2011-04-08 14:38 ` [PATCHv2 7/7] basic_mmio_gpio: support direction registers Anton Vorontsov
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1302272211-30242-8-git-send-email-jamie@jamieiles.com \
--to=jamie@jamieiles.com \
--cc=arnd@arndb.de \
--cc=cbouatmailru@gmail.com \
--cc=grant.likely@secretlab.ca \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@arm.linux.org.uk \
--cc=nico@fluxnic.net \
--cc=tglx@linutronix.de \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®