RE: [PATCH v6] x86: load FPU registers on return to userland

[David Laight <David.Laight@ACULAB.COM>]

From: 'Sebastian Andrzej Siewior'
> Sent: 15 January 2019 13:15
> On 2019-01-15 12:44:53 [+0000], David Laight wrote:
> > Once this is done it might be worth while adding a parameter to
> > kernel_fpu_begin() to request the registers only when they don't
> > need saving.
> > This would benefit code paths where the gains are reasonable but not massive.
> 
> So if saving + FPU code is a small win why not do this always?

I was thinking of the case when the cost of the fpu save is greater
than the saving.
This might be true for (say) a crc on a short buffer.

> > The return value from kernel_fpu_begin() ought to indicate which
> > registers are available - none, SSE, SSE2, AVX, AVX512 etc.
> > So code can use an appropriate implementation.
> > (I've not looked to see if this is already the case!)
> 
> Either everything is saved or nothing. So if SSE registers are saved
> then AVX512 are, too.

(I know that - I've written fpu save code for AVX).
I was thinking that the return value would depend on what the cpu supports.

In fact, given some talk about big-little cpus it might be worth being
able to ask for a specific register set.
Potentially that could cause a processor switch.

	David

-
Registered Address Lakeside, Bramley Road, Mount Farm, Milton Keynes, MK1 1PT, UK
Registration No: 1397386 (Wales)