* Re: mmc select voltage functionality
[not found] <655340.80743.qm@web44811.mail.sp1.yahoo.com>
@ 2007-11-26 17:46 ` Pierre Ossman
0 siblings, 0 replies; only message in thread
From: Pierre Ossman @ 2007-11-26 17:46 UTC (permalink / raw)
To: Madhusudhan C; +Cc: linux-kernel
On Thu, 22 Nov 2007 05:34:11 -0800 (PST)
Madhusudhan C <madhu_lkml@yahoo.com> wrote:
> Hi Pierre,
>
> I have a question on the mmc_select_voltage fn of the mmc core file drivers/mmc/core/core.c.
>
> During the power up sequence the mmc_power_up fn sets the OCR bit to setup 3V. Subsequentely the mmc_select_voltage fn selects the lowest voltage
> the card can support.The host->ios.power_mode is not changed to MMC_POWER_UP before calling mmc_set_ios from this function hence the power_mode remains in MMC_POWER_ON state.So my question is, how should the controller driver handle this change in volatge. Under which case of power mode should the controller driver change the voltage again when a dual voltage card is detected?
>
To be completely correct, the MMC layer should probably power down the card first, yes. Right now most drivers will handle all of these things as they see fit. Haven't seen a single bug report about it yet so...
Just change the voltage in whatever way makes sense for your controller.
Rgds
--
-- Pierre Ossman
Linux kernel, MMC maintainer http://www.kernel.org
PulseAudio, core developer http://pulseaudio.org
rdesktop, core developer http://www.rdesktop.org
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2007-11-26 17:46 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
[not found] <655340.80743.qm@web44811.mail.sp1.yahoo.com>
2007-11-26 17:46 ` mmc select voltage functionality Pierre Ossman
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®