[BUG REPORT!!!] [PATCH 19/49] pcmcia: remove remaining in-kernel pcmcia_get_configuration_info() users

[Komuro <komurojun-mbn@nifty.com>]

Dear Dominik

Unfortunately, your path "[PATCH 19/49] pcmcia: remove remaining in-kernel
pcmcia_get_configuration_info() users"
broke the "serial_cs" and other drivers.

You replace "config->BasePort2" to "link->io.BasePort2" at serial_cs. 

But link->io.BasePort2, link->io.NumPorts2(etc) 
does not contain correct value (it is zero).

Please fix this problem (or reveart the patch).


Best Regards
Komuro

Here is your patch.
>--- a/drivers/serial/serial_cs.c
>+++ b/drivers/serial/serial_cs.c
>@@ -488,23 +488,23 @@ static int simple_config_check_notpicky(struct pcmcia_device *p_dev,
> static int simple_config(struct pcmcia_device *link)
> {
> 	struct serial_info *info = link->priv;
>-	config_info_t config;
>-	int i, try;
>+	int i = -ENODEV, try;
> 
> 	/* If the card is already configured, look up the port and irq */
>-	i = pcmcia_get_configuration_info(link, &config);
>-	if ((i == CS_SUCCESS) && (config.Attributes & CONF_VALID_CLIENT)) {
>+	if (link->function_config) {
> 		unsigned int port = 0;
>-		if ((config.BasePort2 != 0) && (config.NumPorts2 == 8)) {
>-			port = config.BasePort2;
>+		if ((link->io.BasePort2 != 0) &&
>+		    (link->io.NumPorts2 == 8)) {
>+			port = link->io.BasePort2;
> 			info->slave = 1;
> 		} else if ((info->manfid == MANFID_OSITECH) &&
>-			   (config.NumPorts1 == 0x40)) {
>-			port = config.BasePort1 + 0x28;
>+			   (link->io.NumPorts1 == 0x40)) {
>+			port = link->io.BasePort1 + 0x28;
> 			info->slave = 1;
> 		}
> 		if (info->slave) {
>-			return setup_serial(link, info, port, config.AssignedIRQ);
>+			return setup_serial(link, info, port,
>+					    link->irq.AssignedIRQ);
 		}
 	}