Re: [PATCH] [RFC] fs: Possible filp_open race experiment

[Greg Kroah-Hartman <gregkh@linuxfoundation.org>]

On Tue, Jan 31, 2017 at 06:29:36AM +0100, Marek Vasut wrote:
> +CC Greg, LKML as I don't quite know where this should go.

You do know about linux-fsdevel, right?

> On 01/18/2017 12:16 AM, Marek Vasut wrote:
> > I believe there is a possible race condition when configfs attributes
> > trigger filp_open() from the kernel. I initially observed the problem
> > on Linux 4.4 when loading DT overlay , which in turn loads a driver
> > which loads firmware. After some further investigation, I came up with
> > the following minimal-ish example patch, which can trigger the same
> > behavior on Linux 4.10-rc4 (next 20170117).

What in-kernel code causes this problem?  I didn't think DT overlays
were a feature in 4.4, are you running with code that isn't in the
normal releases?

> > The core of the demo is in cfs_over_item_dtbo_write(), which just checks
> > for valid current->fs . This function is triggered by writing data into
> > configfs binary attribute, ie.:

Why are you caring about current->fs?

> > $ mkdir /sys/kernel/config/test/overlays/1/dtbo
> > $ cat file_17201_bytes_long > /sys/kernel/config/test/overlays/1/dtbo
> > 
> > I believe the 'cat' program exits quickly and thus calls fs_exit()
> > before the cfs_over_item_dtbo_write() is called.

How can exit be called before write?

> > Any attempts to
> > access FS (like ie. loading firmware from FS) from that function will
> > therefore fail (by crashing the kernel, NULL pointer dereference in
> > set_root_rcu() in fs/namei.c).
> > 
> > On the other hand, replacing 'cat' with 'dd' yields different result:
> > 
> > $ dd if=file_17201_bytes_long of=/sys/kernel/config/test/overlays/1/dtbo
> > 
> > The kernel does not crash. I believe this is because dd takes slightly
> > longer to complete, so the cfs_over_item_dtbo_write() can complete
> > before the dd process gets to calling fs_exit() and so the filesystem
> > access is still available, thus current->fs is valid.

cat and dd act differently, if you strace them, it should show the
differences, perhaps you can narrow it down there?

> > Note that when using DT overlays (whose configfs interface is not yet
> > mainline),

Ah, we can't do anything about code that is not merged, perhaps it is
just buggy? :)

> > there can easily be a device which requires a firmware in
> > the DT overlay. Such device will invoke firmware load, which uses the
> > filp_open() and will thus trigger the behavior above. Depending on
> > whether one uses dd or cat, the kernel will either crash or not.
> > 
> > Any ideas ?

I think you need to fix your device tree overlay code...

thanks,

greg k-h