[PATCH v6 7/7] mtd: spi-nor: macronix: Add support for mx66lm1g45g

[Tudor Ambarus <tudor.ambarus@microchip.com>]

mx66lm1g45g supports just 1-1-1, 8-8-8 and 8D-8D-8D modes. There are
versions of mx66lm1g45g which do not support SFDP, thus use
SPI_NOR_SKIP_SFDP. The RDID command issued through the octal peripheral
interface outputs data always in STR mode for whatever reason. Since
8D-8D-8S is not common, avoid reading the ID when enabling the octal dtr
mode. Instead, read back the CR2 to check if the switch was successful.
Tested in 1-1-1 and 8d-8d-8d modes using sama7g5 QSPI IP.

Signed-off-by: Tudor Ambarus <tudor.ambarus@microchip.com>
---
# cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/jedec_id
c2853b
# cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/manufacturer
macronix
# cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/partname
mx66lm1g45g
# cat /sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/sfdp
cat: can't open '/sys/devices/platform/soc/e080c000.spi/spi_master/spi1/spi1.0/spi-nor/sfdp': No such file or directory

 drivers/mtd/spi-nor/macronix.c | 131 +++++++++++++++++++++++++++++++++
 1 file changed, 131 insertions(+)

diff --git a/drivers/mtd/spi-nor/macronix.c b/drivers/mtd/spi-nor/macronix.c
index 97dba1ae7fb1..31b2a9f34e03 100644
--- a/drivers/mtd/spi-nor/macronix.c
+++ b/drivers/mtd/spi-nor/macronix.c
@@ -8,6 +8,130 @@
 
 #include "core.h"
 
+#define SPINOR_OP_READ_CR2		0x71	/* Read Configuration Register 2 */
+#define SPINOR_OP_WRITE_CR2		0x72	/* Write Configuration Register 2 */
+#define SPINOR_OP_MX_DTR_RD		0xee	/* Octa DTR Read Opcode */
+
+#define SPINOR_REG_CR2_MODE_ADDR	0	/* Address of Mode Enable in CR2 */
+#define SPINOR_REG_CR2_DTR_OPI_ENABLE	BIT(1)	/* DTR OPI Enable */
+#define SPINOR_REG_CR2_SPI		0	/* SPI Enable */
+
+/**
+ * Macronix SPI NOR flash operations.
+ */
+#define SPI_NOR_MX_READ_CR2_OP(ndummy, buf, ndata)			\
+	SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_READ_CR2, 0),		\
+		   SPI_MEM_OP_ADDR(4, SPINOR_REG_CR2_MODE_ADDR, 0),	\
+		   SPI_MEM_OP_DUMMY(ndummy, 0),				\
+		   SPI_MEM_OP_DATA_IN(ndata, buf, 0))
+
+#define SPI_NOR_MX_WRITE_CR2_OP(buf, ndata)				\
+	SPI_MEM_OP(SPI_MEM_OP_CMD(SPINOR_OP_WRITE_CR2, 0),		\
+		   SPI_MEM_OP_ADDR(4, SPINOR_REG_CR2_MODE_ADDR, 0),	\
+		   SPI_MEM_OP_NO_DUMMY,					\
+		   SPI_MEM_OP_DATA_OUT(ndata, buf, 0))
+
+static int spi_nor_macronix_read_cr2(struct spi_nor *nor, u8 ndummy, void *sr,
+				     unsigned int nbytes)
+{
+	struct spi_mem_op op = SPI_NOR_MX_READ_CR2_OP(ndummy, sr, nbytes);
+
+	spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
+	return spi_mem_exec_op(nor->spimem, &op);
+}
+
+static int spi_nor_macronix_write_cr2(struct spi_nor *nor, const void *sr,
+				      unsigned int nbytes)
+{
+	struct spi_mem_op op = SPI_NOR_MX_WRITE_CR2_OP(sr, nbytes);
+	int ret;
+
+	spi_nor_spimem_setup_op(nor, &op, nor->reg_proto);
+	ret = spi_nor_write_enable(nor);
+	if (ret)
+		return ret;
+	return spi_mem_exec_op(nor->spimem, &op);
+}
+
+static int spi_nor_macronix_octal_dtr_en(struct spi_nor *nor)
+{
+	u8 *buf = nor->bouncebuf;
+	int i, ret;
+
+	buf[0] = SPINOR_REG_CR2_DTR_OPI_ENABLE;
+	ret = spi_nor_macronix_write_cr2(nor, buf, 1);
+	if (ret)
+		return ret;
+
+	/* Read flash ID to make sure the switch was successful. */
+	ret = spi_nor_read_id(nor, 4, 4, buf, SNOR_PROTO_8_8_8_DTR);
+	if (ret)
+		return ret;
+
+	for (i = 0; i < nor->info->id_len; i++)
+		if (buf[i * 2] != nor->info->id[i])
+			return -EINVAL;
+	return 0;
+}
+
+static int spi_nor_macronix_octal_dtr_dis(struct spi_nor *nor)
+{
+	u8 *buf = nor->bouncebuf;
+	int ret;
+
+	/*
+	 * One byte transactions are not allowed in 8D-8D-8D mode. mx66lm1g45g
+	 * requires that undefined register addresses to keep their value
+	 * unchanged. Its second CR2 byte value is not defined. Read the second
+	 * byte value of CR2 so that we can write it back when disabling
+	 * Octal DTR mode.
+	 */
+	ret = spi_nor_macronix_read_cr2(nor, 4, buf, 2);
+	if (ret)
+		return ret;
+	/* Keep the value of buf[1] unchanged.*/
+	buf[0] = SPINOR_REG_CR2_SPI;
+
+	ret = spi_nor_macronix_write_cr2(nor, buf, 2);
+	if (ret)
+		return ret;
+
+	ret = spi_nor_read_id(nor, 0, 0, buf, nor->reg_proto);
+	if (ret)
+		return ret;
+
+	if (memcmp(buf, nor->info->id, nor->info->id_len)) {
+		dev_dbg(nor->dev, "Failed to disable 8D-8D-8D mode.\n");
+		return -EINVAL;
+	}
+	return 0;
+}
+
+static int spi_nor_macronix_octal_dtr_enable(struct spi_nor *nor, bool enable)
+{
+	return enable ? spi_nor_macronix_octal_dtr_en(nor) :
+			spi_nor_macronix_octal_dtr_dis(nor);
+}
+
+static void mx66lm1g45g_late_init(struct spi_nor *nor)
+{
+	nor->params->octal_dtr_enable = spi_nor_macronix_octal_dtr_enable;
+
+	/* Set the Fast Read settings. */
+	nor->params->hwcaps.mask |= SNOR_HWCAPS_READ_8_8_8_DTR;
+	spi_nor_set_read_settings(&nor->params->reads[SNOR_CMD_READ_8_8_8_DTR],
+				  0, 20, SPINOR_OP_MX_DTR_RD,
+				  SNOR_PROTO_8_8_8_DTR);
+
+	nor->cmd_ext_type = SPI_NOR_EXT_INVERT;
+	nor->params->rdsr_dummy = 4;
+	nor->params->rdsr_addr_nbytes = 4;
+}
+
+static struct spi_nor_fixups mx66lm1g45g_fixups = {
+	.late_init = mx66lm1g45g_late_init,
+};
+
 static int
 mx25l25635_post_bfpt_fixups(struct spi_nor *nor,
 			    const struct sfdp_parameter_header *bfpt_header,
@@ -100,6 +224,13 @@ static const struct flash_info macronix_parts[] = {
 	{ "mx66u2g45g",	 INFO(0xc2253c, 0, 64 * 1024, 4096)
 		NO_SFDP_FLAGS(SECT_4K | SPI_NOR_DUAL_READ | SPI_NOR_QUAD_READ)
 		FIXUP_FLAGS(SPI_NOR_4B_OPCODES) },
+	{ "mx66lm1g45g", INFO(0xc2853b, 0, 64 * 1024, 2048)
+		NO_SFDP_FLAGS(SPI_NOR_SKIP_SFDP | SECT_4K |
+			      SPI_NOR_OCTAL_DTR_READ | SPI_NOR_OCTAL_DTR_PP)
+		FIXUP_FLAGS(SPI_NOR_4B_OPCODES | SPI_NOR_IO_MODE_EN_VOLATILE |
+			    SPI_NOR_SOFT_RESET)
+		.fixups = &mx66lm1g45g_fixups,
+	},
 };
 
 static void macronix_default_init(struct spi_nor *nor)
-- 
2.25.1