Re: [PATCH V2 RESEND] objtool/x86: objtool can confuse memory and stack access

[Josh Poimboeuf <jpoimboe@kernel.org>]

On Thu, Jun 20, 2024 at 04:47:47PM +0200, Alexandre Chartre wrote:
> The encoding of an x86 instruction can include a ModR/M and a SIB
> (Scale-Index-Base) byte to describe the addressing mode of the
> instruction.
> 
> objtool processes all addressing mode with a SIB base of 5 as having
> %rbp as the base register. However, a SIB base of 5 means that the
> effective address has either no base (if ModR/M mod is zero) or %rbp
> as the base (if ModR/M mod is 1 or 2). This can cause objtool to confuse
> an absolute address access with a stack operation.
> 
> For example, objtool will see the following instruction:
> 
>  4c 8b 24 25 e0 ff ff    mov    0xffffffffffffffe0,%r12
> 
> as a stack operation (i.e. similar to: mov -0x20(%rbp), %r12).
> 
> [Note that this kind of weird absolute address access is added by the
>  compiler when using KASAN.]
> 
> If this perceived stack operation happens to reference the location
> where %r12 was pushed on the stack then the objtool validation will
> think that %r12 is being restored and this can cause a stack state
> mismatch.
> 
> This kind behavior was seen on xfs code, after a minor change (convert
> kmem_alloc() to kmalloc()):
> 
> >> fs/xfs/xfs.o: warning: objtool: xfs_da_grow_inode_int+0x6c1: stack state mismatch: reg1[12]=-2-48 reg2[12]=-1+0
> 
> Reported-by: kernel test robot <lkp@intel.com>
> Closes: https://lore.kernel.org/oe-kbuild-all/202402220435.MGN0EV6l-lkp@intel.com/
> Signed-off-by: Alexandre Chartre <alexandre.chartre@oracle.com>

Thanks, queueing...

-- 
Josh