[PATCH v3 0/5] Add Per-transport SCMI debug statistics

[Luke Parkin <luke.parkin@arm.com>]

This series adds support for tracking Arm SCMI statistics [Patch 2/3]
A config option to enable this [Patch 2]
Cleans up a unneeded call to handle_scmi_info [Patch 1]
In [Patch 4] a selection of new debugfs entries to present these statistics
Then finally in [Patch 5] enabled writing on the debugfs entries to reset stats

Based on v6.9, Tested on Arm Juno [1]

Thanks,
Luke

[1]: https://www.arm.com/products/development-tools/development-boards/juno-arm-dev-platform

V2->V3
Switch statistic counters to an array to store statistics.
Add more statistics
Add the ability to reset statistics, both individually and all
V1->V2
Add a minor fix removing an unneeded call to handle_to_scmi_info
Use new scmi_log_stats op/no-op rather than if(IS_ENABLED)
Drop unneeded atomic_set's
Use a helper function for stats debugfs creation

Luke Parkin (5):
  firmware: arm_scmi: Remove superfluous handle_to_scmi_info
  firmware: arm_scmi: Add support for tracking statistics
  firmware: arm_scmi: Track basic SCMI statistics
  firmware: arm_scmi: Create debugfs files for statistics
  firmware: arm_scmi: Reset statistics

 drivers/firmware/arm_scmi/Kconfig  |  11 +++
 drivers/firmware/arm_scmi/common.h |   9 ++
 drivers/firmware/arm_scmi/driver.c | 138 +++++++++++++++++++++++++++--
 3 files changed, 150 insertions(+), 8 deletions(-)

-- 
2.34.1