[PATCH v2 02/15] arm64: dts: qcom: msm8998: Move PCIe phy and GPIOs to root port node

[Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>]

The PCIe phy reference and the perst GPIO property are per root port
and belong in the root port node (pcie@0), not in the RC controller
node. Move phys, phy-names, and perst-gpios from the controller to
pcie0_port0, adding a label to this node to allow board-level
overrides, and renaming perst-gpios to reset-gpios to match the
binding used in the root port context.

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>
Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/msm8998.dtsi | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/arch/arm64/boot/dts/qcom/msm8998.dtsi b/arch/arm64/boot/dts/qcom/msm8998.dtsi
index 5038d0009c1a..bd8b69e323e1 100644
--- a/arch/arm64/boot/dts/qcom/msm8998.dtsi
+++ b/arch/arm64/boot/dts/qcom/msm8998.dtsi
@@ -928,8 +928,6 @@ pcie0: pcie@1c00000 {
 			#address-cells = <3>;
 			#size-cells = <2>;
 			num-lanes = <1>;
-			phys = <&pcie_phy>;
-			phy-names = "pciephy";
 			status = "disabled";
 
 			ranges = <0x01000000 0x0 0x00000000 0x1b200000 0x0 0x100000>,
@@ -969,13 +967,15 @@ pcie0: pcie@1c00000 {
 
 			power-domains = <&gcc PCIE_0_GDSC>;
 			iommu-map = <0x100 &anoc1_smmu 0x1480 1>;
-			perst-gpios = <&tlmm 35 GPIO_ACTIVE_LOW>;
 
 			pcie@0 {
 				device_type = "pci";
 				reg = <0x0 0x0 0x0 0x0 0x0>;
 				bus-range = <0x01 0xff>;
 
+				phys = <&pcie_phy>;
+				reset-gpios = <&tlmm 35 GPIO_ACTIVE_LOW>;
+
 				#address-cells = <3>;
 				#size-cells = <2>;
 				ranges;

-- 
2.34.1