Re: [PATCH v2 12/15] arm64: dts: qcom: sm8650: Move PCIe phy and GPIOs to root port node

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 9/17/26 2:25 PM, Krishna Chaitanya Chundru wrote:
> The PCIe phy reference and the perst/wake GPIO properties are
> per root port and belong in the root port node (pcie@0), not in the
> RC controller node. Move phys and phy-names from the controller to
> the existing pcieport0 and pcie1_port0, allowing board-level
> overrides. Move perst-gpios/wake-gpios from the controller overrides
> to the respective port nodes in the board files, renaming perst-gpios
> to reset-gpios to match the binding used in the root port context.
> 
> Reviewed-by: Neil Armstrong <neil.armstrong@linaro.org>
> Signed-off-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
> ---

[...]

>  &pcie1_port0 {
> +	reset-gpios = <&tlmm 97 GPIO_ACTIVE_LOW>;
> +	wake-gpios = <&tlmm 99 GPIO_ACTIVE_LOW>;
>  	/* Renesas μPD720201 PCIe USB3.0 HOST CONTROLLER */
>  	usb-controller@0 {

ditto

Konrad