[PATCH] arm64: dts: qcom: monaco: Add EL2 overlay for monaco-arduino-monza

[PATCH] arm64: dts: qcom: monaco: Add EL2 overlay for monaco-arduino-monza

[Pablo del Arco]

Build an EL2 combined DTB for the Arduino VENTUNO Q (monaco-arduino-monza)
from the base DTB and monaco-el2.dtbo, as monaco-evk-el2.dtb already does
for the Monaco EVK.

The board boots under Gunyah by default. This DTB lets it run Linux at EL2
with KVM when the boot firmware is set up for that.

Signed-off-by: Pablo del Arco <pablodelarco1@gmail.com>
---
Build tested with CHECK_DTBS=y on top of qcom for-next. Not boot tested at EL2,
the board ships boot firmware set up for Gunyah.

 arch/arm64/boot/dts/qcom/Makefile | 4 ++++
 1 file changed, 4 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/Makefile b/arch/arm64/boot/dts/qcom/Makefile
index 88230c4e0..859586cdc 100644
--- a/arch/arm64/boot/dts/qcom/Makefile
+++ b/arch/arm64/boot/dts/qcom/Makefile
@@ -68,6 +68,10 @@ dtb-$(CONFIG_ARCH_QCOM)	+= mahua-lenovo-thinkpad-t14s-gen7-lcd.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= milos-fairphone-fp6.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= milos-nothing-asteroids.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= monaco-arduino-monza.dtb
+
+monaco-arduino-monza-el2-dtbs	:= monaco-arduino-monza.dtb monaco-el2.dtbo
+
+dtb-$(CONFIG_ARCH_QCOM)	+= monaco-arduino-monza-el2.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= monaco-ac-evk.dtb
 dtb-$(CONFIG_ARCH_QCOM)	+= monaco-evk.dtb
 
-- 
2.43.0