From: Paul Cercueil <paul.cercueil@bootlin.com>
To: Pratyush Yadav <pratyush@kernel.org>,
Michael Walle <mwalle@kernel.org>,
Takahiro Kuwano <takahiro.kuwano@infineon.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Richard Weinberger <richard@nod.at>,
Vignesh Raghavendra <vigneshr@ti.com>,
Mark Brown <broonie@kernel.org>,
Thomas Petazzoni <thomas.petazzoni@bootlin.com>
Cc: Kees Cook <kees@kernel.org>, Tony Luck <tony.luck@intel.com>,
"Guilherme G . Piccoli" <gpiccoli@igalia.com>,
linux-mtd@lists.infradead.org, linux-kernel@vger.kernel.org,
linux-spi@vger.kernel.org, Bharat Bhushan <bbhushan2@marvell.com>,
Sunil Kovvuri Goutham <sgoutham@marvell.com>,
Tanmay Jagdale <tanmay@marvell.com>,
Paul Cercueil <paul.cercueil@bootlin.com>
Subject: [PATCH v3 5/7] spi: cadence-xspi: Add irq-less support
Date: Wed, 14 Oct 2026 17:42:59 +0200 [thread overview]
Message-ID: <20261014154301.157755-6-paul.cercueil@bootlin.com> (raw)
In-Reply-To: <20261014154301.157755-1-paul.cercueil@bootlin.com>
From: Tanmay Jagdale <tanmay@marvell.com>
Make the interrupt line optional. If not provided, the driver will
instead resort to polling registers.
This can be useful in itself, but will be used later to support write on
kernel panic.
Note the cdns_xspi_is_{sdma,stig}_ready() seem to have moved for no
reason; they were actually moved out of a conditional compilation block
(#ifdef CONFIG_64BIT), as they are needed in conf-independent paths now.
Signed-off-by: Tanmay Jagdale <tanmay@marvell.com>
Co-developed-by: Paul Cercueil <paul.cercueil@bootlin.com>
Signed-off-by: Paul Cercueil <paul.cercueil@bootlin.com>
---
Notes:
v2: Make sure we only enable interrupts if not using polling mode
v3: No change
drivers/spi/spi-cadence-xspi.c | 104 ++++++++++++++++++---------------
1 file changed, 58 insertions(+), 46 deletions(-)
diff --git a/drivers/spi/spi-cadence-xspi.c b/drivers/spi/spi-cadence-xspi.c
index 095bf640b379..2a2a40bf0a4c 100644
--- a/drivers/spi/spi-cadence-xspi.c
+++ b/drivers/spi/spi-cadence-xspi.c
@@ -365,6 +365,38 @@ static int cdns_xspi_wait_for_controller_idle(struct cdns_xspi_dev *cdns_xspi)
100, 1000);
}
+static bool cdns_xspi_is_stig_ready(struct cdns_xspi_dev *cdns_xspi, bool sleep)
+{
+ u32 ctrl_stat;
+
+ return !readl_relaxed_poll_timeout
+ (cdns_xspi->iobase + CDNS_XSPI_CTRL_STATUS_REG,
+ ctrl_stat,
+ ((ctrl_stat & BIT(3)) == 0),
+ sleep ? MRVL_XSPI_POLL_DELAY_US : 0,
+ sleep ? MRVL_XSPI_POLL_TIMEOUT_US : 0);
+}
+
+static bool cdns_xspi_is_sdma_ready(struct cdns_xspi_dev *cdns_xspi, bool sleep)
+{
+ u32 ctrl_stat;
+
+ if (readl_relaxed_poll_timeout
+ (cdns_xspi->iobase + CDNS_XSPI_INTR_STATUS_REG,
+ ctrl_stat,
+ (ctrl_stat & CDNS_XSPI_SDMA_TRIGGER),
+ sleep ? MRVL_XSPI_POLL_DELAY_US : 0,
+ sleep ? MRVL_XSPI_POLL_TIMEOUT_US : 0)) {
+ return false;
+ }
+
+ /* Clear the flag */
+ writel(CDNS_XSPI_SDMA_TRIGGER,
+ cdns_xspi->iobase + CDNS_XSPI_INTR_STATUS_REG);
+
+ return true;
+}
+
static void cdns_xspi_trigger_command(struct cdns_xspi_dev *cdns_xspi,
u32 cmd_regs[6])
{
@@ -532,7 +564,8 @@ static int cdns_xspi_send_stig_command(struct cdns_xspi_dev *cdns_xspi,
writel(FIELD_PREP(CDNS_XSPI_CTRL_WORK_MODE, CDNS_XSPI_WORK_MODE_STIG),
cdns_xspi->iobase + CDNS_XSPI_CTRL_CONFIG_REG);
- cdns_xspi->set_interrupts_handler(cdns_xspi, true);
+ if (cdns_xspi->irq >= 0)
+ cdns_xspi->set_interrupts_handler(cdns_xspi, true);
cdns_xspi->sdma_error = false;
memset(cmd_regs, 0, sizeof(cmd_regs));
@@ -562,16 +595,25 @@ static int cdns_xspi_send_stig_command(struct cdns_xspi_dev *cdns_xspi,
cdns_xspi_trigger_command(cdns_xspi, cmd_regs);
- wait_for_completion(&cdns_xspi->sdma_complete);
- if (cdns_xspi->sdma_error) {
- cdns_xspi->set_interrupts_handler(cdns_xspi, false);
+ if (cdns_xspi->irq >= 0) {
+ wait_for_completion(&cdns_xspi->sdma_complete);
+ if (cdns_xspi->sdma_error) {
+ cdns_xspi->set_interrupts_handler(cdns_xspi, false);
+ return -EIO;
+ }
+ } else if (!cdns_xspi_is_sdma_ready(cdns_xspi, true)) {
return -EIO;
}
+
cdns_xspi->sdma_handler(cdns_xspi);
}
- wait_for_completion(&cdns_xspi->cmd_complete);
- cdns_xspi->set_interrupts_handler(cdns_xspi, false);
+ if (cdns_xspi->irq >= 0) {
+ wait_for_completion(&cdns_xspi->cmd_complete);
+ cdns_xspi->set_interrupts_handler(cdns_xspi, false);
+ } else if (!cdns_xspi_is_stig_ready(cdns_xspi, true)) {
+ return -EIO;
+ }
cmd_status = cdns_xspi_check_command_status(cdns_xspi);
if (cmd_status)
@@ -1052,38 +1094,6 @@ static int cdns_xspi_prepare_transfer(int cs, int dir, int len, u32 *cmd_regs)
return 0;
}
-static bool cdns_xspi_is_stig_ready(struct cdns_xspi_dev *cdns_xspi, bool sleep)
-{
- u32 ctrl_stat;
-
- return !readl_relaxed_poll_timeout
- (cdns_xspi->iobase + CDNS_XSPI_CTRL_STATUS_REG,
- ctrl_stat,
- ((ctrl_stat & BIT(3)) == 0),
- sleep ? MRVL_XSPI_POLL_DELAY_US : 0,
- sleep ? MRVL_XSPI_POLL_TIMEOUT_US : 0);
-}
-
-static bool cdns_xspi_is_sdma_ready(struct cdns_xspi_dev *cdns_xspi, bool sleep)
-{
- u32 ctrl_stat;
-
- if (readl_relaxed_poll_timeout
- (cdns_xspi->iobase + CDNS_XSPI_INTR_STATUS_REG,
- ctrl_stat,
- (ctrl_stat & CDNS_XSPI_SDMA_TRIGGER),
- sleep ? MRVL_XSPI_POLL_DELAY_US : 0,
- sleep ? MRVL_XSPI_POLL_TIMEOUT_US : 0)) {
- return false;
- }
-
- /* Clear the flag */
- writel(CDNS_XSPI_SDMA_TRIGGER,
- cdns_xspi->iobase + CDNS_XSPI_INTR_STATUS_REG);
-
- return true;
-}
-
static int cdns_xspi_transfer_one_message_b0(struct spi_controller *controller,
struct spi_message *m)
{
@@ -1276,15 +1286,17 @@ static int cdns_xspi_probe(struct platform_device *pdev)
}
#endif
- cdns_xspi->irq = platform_get_irq(pdev, 0);
- if (cdns_xspi->irq < 0)
- return -ENXIO;
+ cdns_xspi->irq = platform_get_irq_optional(pdev, 0);
+ if (cdns_xspi->irq < 0 && cdns_xspi->irq != -ENXIO)
+ return cdns_xspi->irq;
- ret = devm_request_irq(dev, cdns_xspi->irq, cdns_xspi_irq_handler,
- IRQF_SHARED, pdev->name, cdns_xspi);
- if (ret) {
- dev_err(dev, "Failed to request IRQ: %d\n", cdns_xspi->irq);
- return ret;
+ if (cdns_xspi->irq >= 0) {
+ ret = devm_request_irq(dev, cdns_xspi->irq, cdns_xspi_irq_handler,
+ IRQF_SHARED, pdev->name, cdns_xspi);
+ if (ret) {
+ dev_err(dev, "Failed to request IRQ: %d\n", cdns_xspi->irq);
+ return ret;
+ }
}
#ifdef CONFIG_64BIT
--
2.47.3
next prev parent reply other threads:[~2026-10-14 15:44 UTC|newest]
Thread overview: 8+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-10-14 15:42 [PATCH v3 0/7] spi: Add support for panic mem writes Paul Cercueil
2026-10-14 15:42 ` [PATCH v3 1/7] spi: spi-mem: " Paul Cercueil
2026-10-14 15:42 ` [PATCH v3 2/7] mtd: spi-nor: Wait for NOR ready with poll_timeout_us() Paul Cercueil
2026-10-14 15:42 ` [PATCH v3 3/7] mtd: spi-nor: Add support for panic writes Paul Cercueil
2026-10-14 15:42 ` [PATCH v3 4/7] spi: cadence-xspi: Clear "SDMA ready" IRQ flag after polling Paul Cercueil
2026-10-14 15:42 ` Paul Cercueil [this message]
2026-10-14 15:43 ` [PATCH v3 6/7] spi: cadence-xspi: Add support for panic writes Paul Cercueil
2026-10-14 15:43 ` [PATCH v3 7/7] spi: dt-bindings: cadence: Make XSPI's IRQ line optional Paul Cercueil
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20261014154301.157755-6-paul.cercueil@bootlin.com \
--to=paul.cercueil@bootlin.com \
--cc=bbhushan2@marvell.com \
--cc=broonie@kernel.org \
--cc=gpiccoli@igalia.com \
--cc=kees@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=linux-spi@vger.kernel.org \
--cc=miquel.raynal@bootlin.com \
--cc=mwalle@kernel.org \
--cc=pratyush@kernel.org \
--cc=richard@nod.at \
--cc=sgoutham@marvell.com \
--cc=takahiro.kuwano@infineon.com \
--cc=tanmay@marvell.com \
--cc=thomas.petazzoni@bootlin.com \
--cc=tony.luck@intel.com \
--cc=vigneshr@ti.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®