[PATCH v10 01/12] iio: adc: ad7768-1: Ensure SYNC_IN pulse minimum timing requirement

[Jonathan Santos <Jonathan.Santos@analog.com>]

The SYNC_IN pulse width must be at least 1.5 x Tmclk, corresponding to
~2.5 µs at the lowest supported MCLK frequency. Add a 3 µs delay to
ensure reliable synchronization timing even for the worst-case scenario.

Signed-off-by: Jonathan Santos <Jonathan.Santos@analog.com>
---
v10 Changes:
* New patch.
---
 drivers/iio/adc/ad7768-1.c | 23 +++++++++++++++++++----
 1 file changed, 19 insertions(+), 4 deletions(-)

diff --git a/drivers/iio/adc/ad7768-1.c b/drivers/iio/adc/ad7768-1.c
index 51134023534a..8b414a102864 100644
--- a/drivers/iio/adc/ad7768-1.c
+++ b/drivers/iio/adc/ad7768-1.c
@@ -252,6 +252,24 @@ static const struct regmap_config ad7768_regmap24_config = {
 	.max_register = AD7768_REG24_COEFF_DATA,
 };
 
+static int ad7768_send_sync_pulse(struct ad7768_state *st)
+{
+	/*
+	 * The datasheet specifies a minimum SYNC_IN pulse width of 1.5 × Tmclk,
+	 * where Tmclk is the MCLK period. The supported MCLK frequencies range
+	 * from 0.6 MHz to 17 MHz, which corresponds to a minimum SYNC_IN pulse
+	 * width of approximately 2.5 µs in the worst-case scenario (0.6 MHz).
+	 *
+	 * Add a delay to ensure the pulse width is always sufficient to
+	 * trigger synchronization.
+	 */
+	gpiod_set_value_cansleep(st->gpio_sync_in, 1);
+	fsleep(3);
+	gpiod_set_value_cansleep(st->gpio_sync_in, 0);
+
+	return 0;
+}
+
 static int ad7768_set_mode(struct ad7768_state *st,
 			   enum ad7768_conv_mode mode)
 {
@@ -339,10 +357,7 @@ static int ad7768_set_dig_fil(struct ad7768_state *st,
 		return ret;
 
 	/* A sync-in pulse is required every time the filter dec rate changes */
-	gpiod_set_value(st->gpio_sync_in, 1);
-	gpiod_set_value(st->gpio_sync_in, 0);
-
-	return 0;
+	return ad7768_send_sync_pulse(st);
 }
 
 static int ad7768_set_freq(struct ad7768_state *st,
-- 
2.34.1