Re: [PATCH v3 2/2] arm64: dts: qcom: Add PCIe3 and PCIe5 regulators for HAMAO-IOT-EVK board

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 11/18/25 11:11 AM, Ziyue Zhang wrote:
> 
> On 11/13/2025 5:16 AM, Dmitry Baryshkov wrote:
>> On Wed, Nov 12, 2025 at 05:03:16PM +0800, Ziyue Zhang wrote:
>>> HAMAO IoT EVK uses PCIe5 to connect an SDX65 module for WWAN functionality
>>> and PCIe3 to connect a SATA controller. These interfaces require multiple
>>> voltage rails: PCIe5 needs 3.3V supplied by vreg_wwan, while PCIe3 requires
>>> 12V, 3.3V, and 3.3V AUX rails, controlled via PMIC GPIOs.
>>>
>>> Add the required fixed regulators with related pin configuration, and
>>> connect them to the PCIe3 and PCIe5 ports to ensure proper power for the
>>> SDX65 module and SATA controller.
>>>
>>> Signed-off-by: Ziyue Zhang <ziyue.zhang@oss.qualcomm.com>
>>> Reviewed-by: Krishna Chaitanya Chundru <krishna.chundru@oss.qualcomm.com>
>>> ---
>>>   arch/arm64/boot/dts/qcom/hamoa-iot-evk.dts | 83 ++++++++++++++++++++++
>>>   1 file changed, 83 insertions(+)
>>>
>>> +&pmc8380_3_gpios {
>>> +    pm_sde7_aux_3p3_en: pcie-aux-3p3-default-state {
>> What is sde7? Other than that:
>>
>>
>> Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
>>
> Hi Dmitry
> 
> I’m not sure what “sde7” refers to specifically. I saw this name in the

It refers to "SD Express" which was connected to that PCIe host on some
flavors of the internal boards, and the naming must have stuck..

Konrad