RE: [PATCH 2/2] usb: musb: Stop bulk endpoint while queue is rotated

[Andrew Goodbody <andrew.goodbody@cambrionix.com>]

> From: Sergei Shtylyov [mailto:sergei.shtylyov@cogentembedded.com]
> On 05/20/2016 08:06 PM, Andrew Goodbody wrote:
> 
> >>> Ensure that the endpoint is stopped by clearing REQPKT before
> >>> clearing DATAERR_NAKTIMEOUT before rotating the queue on the
> >>> dedicated bulk endpoint.
> >>> This addresses an issue where a race could result in the endpoint
> >>> receiving data before it was reprogrammed resulting in a warning
> >>> about such data from musb_rx_reinit before it was thrown away.
> >>> The data thrown away was a valid packet that had been correctly
> >>> ACKed which meant the host and device got out of sync.
> >>>
> >>> Signed-off-by: Andrew Goodbody
> <andrew.goodbody@cambrionix.com>
> >>> Cc: stable@vger.kernel.org
> >>> ---
> >>>  drivers/usb/musb/musb_host.c | 2 ++
> >>>  1 file changed, 2 insertions(+)
> >>>
> >>> diff --git a/drivers/usb/musb/musb_host.c
> >>> b/drivers/usb/musb/musb_host.c index 30e0d65..777ff30 100644
> >>> --- a/drivers/usb/musb/musb_host.c
> >>> +++ b/drivers/usb/musb/musb_host.c
> >>> @@ -999,6 +999,8 @@ static void musb_bulk_nak_timeout(struct musb
> >> *musb, struct musb_hw_ep *ep,
> >>>  		/* clear nak timeout bit */
> >>>  		rx_csr = musb_readw(epio, MUSB_RXCSR);
> >>>  		rx_csr |= MUSB_RXCSR_H_WZC_BITS;
> >>> +		rx_csr &= ~MUSB_RXCSR_H_REQPKT;
> >>> +		musb_writew(epio, MUSB_RXCSR, rx_csr);
> >>>  		rx_csr &= ~MUSB_RXCSR_DATAERROR;
> >>>  		musb_writew(epio, MUSB_RXCSR, rx_csr);
> >>
> >>     Can we not clear both in one write?
> >
> > Section 16.3.8.2.2.1.2 of the TRM says to clear REQPKT before
> DATAERR_NAKTIMEOUT.
> 
>     Right, the MUSB programmer's guide also says that. Then a comment
> wouldn't hurt here.

I'll add that for v2, thanks.

Andrew

> > Andrew
> 
> MBR, Sergei