[PATCH 0269/1285] Replace numeric parameter like 0444 with macro

[Baole Ni <baolex.ni@intel.com>]

I find that the developers often just specified the numeric value
when calling a macro which is defined with a parameter for access permission.
As we know, these numeric value for access permission have had the corresponding macro,
and that using macro can improve the robustness and readability of the code,
thus, I suggest replacing the numeric parameter with the macro.

Signed-off-by: Chuansheng Liu <chuansheng.liu@intel.com>
Signed-off-by: Baole Ni <baolex.ni@intel.com>
---
 drivers/infiniband/ulp/ipoib/ipoib_main.c | 6 +++---
 1 file changed, 3 insertions(+), 3 deletions(-)

diff --git a/drivers/infiniband/ulp/ipoib/ipoib_main.c b/drivers/infiniband/ulp/ipoib/ipoib_main.c
index 5f58c41..eed3e3c 100644
--- a/drivers/infiniband/ulp/ipoib/ipoib_main.c
+++ b/drivers/infiniband/ulp/ipoib/ipoib_main.c
@@ -65,15 +65,15 @@ MODULE_VERSION(DRV_VERSION);
 int ipoib_sendq_size __read_mostly = IPOIB_TX_RING_SIZE;
 int ipoib_recvq_size __read_mostly = IPOIB_RX_RING_SIZE;
 
-module_param_named(send_queue_size, ipoib_sendq_size, int, 0444);
+module_param_named(send_queue_size, ipoib_sendq_size, int, S_IRUSR | S_IRGRP | S_IROTH);
 MODULE_PARM_DESC(send_queue_size, "Number of descriptors in send queue");
-module_param_named(recv_queue_size, ipoib_recvq_size, int, 0444);
+module_param_named(recv_queue_size, ipoib_recvq_size, int, S_IRUSR | S_IRGRP | S_IROTH);
 MODULE_PARM_DESC(recv_queue_size, "Number of descriptors in receive queue");
 
 #ifdef CONFIG_INFINIBAND_IPOIB_DEBUG
 int ipoib_debug_level;
 
-module_param_named(debug_level, ipoib_debug_level, int, 0644);
+module_param_named(debug_level, ipoib_debug_level, int, S_IRUSR | S_IWUSR | S_IRGRP | S_IROTH);
 MODULE_PARM_DESC(debug_level, "Enable debug tracing if > 0");
 #endif
 
-- 
2.9.2