Re: [PATCH WIP v2 3/8] media: qcom: camss: Prepare CSID for C-PHY support

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 12/4/25 5:32 PM, David Heidelberg via B4 Relay wrote:
> From: David Heidelberg <david@ixit.cz>
> 
> Inherit C-PHY information from CSIPHY, so we can configure CSID
> properly.
> 
> CSI2_RX_CFG0_PHY_TYPE_SEL must be set to 1, when C-PHY mode is used.
> 
> Signed-off-by: David Heidelberg <david@ixit.cz>
> ---
>  drivers/media/platform/qcom/camss/camss-csid-gen2.c | 1 +
>  drivers/media/platform/qcom/camss/camss-csid.c      | 1 +
>  drivers/media/platform/qcom/camss/camss-csid.h      | 1 +
>  3 files changed, 3 insertions(+)
> 
> diff --git a/drivers/media/platform/qcom/camss/camss-csid-gen2.c b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> index 2a1746dcc1c5b..033036ae28a4f 100644
> --- a/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> +++ b/drivers/media/platform/qcom/camss/camss-csid-gen2.c
> @@ -183,6 +183,7 @@ static void __csid_configure_rx(struct csid_device *csid,
>  	val = (lane_cnt - 1) << CSI2_RX_CFG0_NUM_ACTIVE_LANES;
>  	val |= phy->lane_assign << CSI2_RX_CFG0_DL0_INPUT_SEL;
>  	val |= phy->csiphy_id << CSI2_RX_CFG0_PHY_NUM_SEL;
> +	val |= csid->phy.cphy << CSI2_RX_CFG0_PHY_TYPE_SEL;

This field is 1-wide, this would be neater:

if (csid->phy.cphy)
	val |= BIT(CSI2_RX_CFG0_PHY_TYPE_SEL);

Konrad