Re: [PATCH v2 0/3] i2c: Add Starfive JHB100 I2C master/slave support

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Wed, May 27, 2026 at 04:50:36PM +0800, lianfeng.ouyang wrote:

> The Starfive JHB100 I2C controller is a variant of the widely-used
> DesignWare I2C IP, with a distinct register layout and enhanced features
> such as SMBus Alert and programmable FIFO depths.
> 
> The series is structured as follows:
> 1.  Adds the device tree binding document for the starfive,jhb100-i2c
>         compatible.
> 2.  Prepares the existing i2c-designware-core by exporting and making
>         certain key functions overridable, allowing code reuse.
> 3.  Introduces the new i2c-starfive-* driver, with separate modules for
>         master and slave functionality, based on the 2023-07 revision of
> 	the Synopsys IP manual.
> 
> Currently, due to the following differences, i2c designware cannot be
> fully reused
> 1.  For high and low level counting settings at different rates, i2c
>         starfive can use IC_SCL-H/LCNT to set SS, FM, FM+, UFM
> 2.  Interrupt clearing is achieved by writing 1 to the corresponding
>         bit of INTR_CLR, while designware reads different clearing
> 	registers
> 3.  Master and slave require separate probe callbacks and cannot rely
>         solely on the runtime mode switching provided by i2c_dw_set_mode()
> 4.  The value of FIFO depth is not obtained through registers, but
>         written through DTS

NAK in this form. We well discourage code duplication and ugly ifdeffery with
full of __weak annotations that may not be present in the regular driver. There
is not even a tiny bit of justification for this nonsense.

TL;DR: this series needs much more work.

> I have written some poorly styled code to reduce changes to i2c designware
> and reuse its functions by keeping aa always true, for example
> 1.  the implementation of i2c-d w_probe_master() differs only for the two
>         IPs in i2c_dw_set_timits_master(). In order to reuse
> 	i2c_dw_probe_master(), i2c_dw_set_timits_master is declared as
> 	__weak. A better approach is to use a callback function, but using
> 	a callback function requires changing more i2c designware files.
> 	I don't know what the attitude of the community is
> 2.  For the operation of clearing interrupt flags, i2c designware reads
>         and i2c starfive writes. Therefore, in order not to modify the
> 	relevant logic of i2c designware, I added a write operation to
> 	sf_reg_read()
> So I think this version of the code is not allowed to merge, but I don't
> know how to handle this situation because if i2c designware is not changed
>  at all, we will have to write code that is similar to i2c designware.
>  Will this type of IP not be allowed to merge?

-- 
With Best Regards,
Andy Shevchenko