Re: [PATCH 0/7] soc: aspeed: Add AST2600 eSPI controller support

[Ivan Mikhaylov <fr0st61te@gmail.com>]

On Fri, 2026-03-13 at 22:36 +0100, Arnd Bergmann wrote:
> On Fri, Mar 13, 2026, at 17:24, Conor Dooley wrote:
> > On Fri, Mar 13, 2026 at 06:07:35PM +0800, aspeedyh wrote:
> > > This series adds initial support for the eSPI controller found on
> > > ASPEED
> > > AST2600 BMC SoCs.
> > > 
> > > The series introduces a eSPI controller framework for ASPEED SoCs
> > > under
> > > drivers/soc/aspeed/, adds AST2600-specific controller support for
> > > peripheral and flash channels, defines the corresponding
> > > devicetree 
> > > binding, and adds the AST2600 eSPI controller node to the SoC
> > > dtsi.
> > > 
> > > The driver is intended to support host-BMC communication over the
> > > BMC-side
> > > eSPI slave controller present on AST2600 systems.
> > 
> > This all seems to be in the wrong places entirely, shouldn't an
> > eSPI
> > driver and bindings go in the spi subsystem?
> 
> From an initial reading, my impression is that patches 1, 2, 3 and 7
> should be modified to use the normal SPI interfaces to implement
> an spi target driver, possibly a combined host/target driver.
> Reworking this should be fairly straightforward because the
> interfaces
> to the SPI core are well documented.

Arnd, that's would be nice if it would be standard SPI device. But what
if eSPI would be a bus? So, I assume all other which lying underneath 
eSPI would be much easier to implement as standard driver data set
SPI/GPIO/I2C with something like devm_regmap_init_espi(like for i2c/spi
or anything else) for example as common part for these drivers.

Thanks.