From: Vladimir Zapolskiy <vladimir.zapolskiy@linaro.org>
To: Tarang Raval <tarang.raval@siliconsignals.io>,
sakari.ailus@linux.intel.com, mehdi.djait@linux.intel.com
Cc: Himanshu Bhavani <himanshu.bhavani@siliconsignals.io>,
Elgin Perumbilly <elgin.perumbilly@siliconsignals.io>,
Mauro Carvalho Chehab <mchehab@kernel.org>,
Hans Verkuil <hverkuil+cisco@kernel.org>,
linux-media@vger.kernel.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH v3 05/17] media: i2c: os05b10: add V4L2 digital gain control
Date: Fri, 24 Jul 2026 16:19:02 +0300 [thread overview]
Message-ID: <fb9b5132-e5b6-405f-b930-8d2b44c3740c@linaro.org> (raw)
In-Reply-To: <20260718200912.16001-6-tarang.raval@siliconsignals.io>
On 7/18/26 23:08, Tarang Raval wrote:
> Stop programming digital gain in the common register sequence and expose it as
> a V4L2_CID_DIGITAL_GAIN control. Initialize the new control and handle writes
> in the ctrl callback.
>
> Signed-off-by: Tarang Raval <tarang.raval@siliconsignals.io>
> Reviewed-by: Mehdi Djait <mehdi.djait@linux.intel.com>
> ---
> drivers/media/i2c/os05b10.c | 11 +++++++++--
> 1 file changed, 9 insertions(+), 2 deletions(-)
>
> diff --git a/drivers/media/i2c/os05b10.c b/drivers/media/i2c/os05b10.c
> index 12c4e2610d6f..abf3d2970900 100644
> --- a/drivers/media/i2c/os05b10.c
> +++ b/drivers/media/i2c/os05b10.c
> @@ -138,7 +138,6 @@ static const struct cci_reg_sequence os05b10_common_regs[] = {
> { CCI_REG8(0x3503), 0x88 },
> { OS05B10_REG_DIGITAL_GAIN, 0x0400 },
> { OS05B10_REG_ANALOG_GAIN_SHORT, 0x0080 },
> - { OS05B10_REG_DIGITAL_GAIN_SHORT, OS05B10_DIGITAL_GAIN_DEFAULT },
> { OS05B10_REG_EXPOSURE_SHORT, 0x000020 },
> { CCI_REG8(0x3600), 0x4d },
> { CCI_REG8(0x3601), 0x08 },
> @@ -549,6 +548,10 @@ static int os05b10_set_ctrl(struct v4l2_ctrl *ctrl)
> ret = cci_write(os05b10->cci, OS05B10_REG_ANALOG_GAIN,
> ctrl->val, NULL);
> break;
> + case V4L2_CID_DIGITAL_GAIN:
> + ret = cci_write(os05b10->cci, OS05B10_REG_DIGITAL_GAIN,
> + ctrl->val, NULL);
OS05B10_REG_DIGITAL_GAIN_SHORT control is removed, but
OS05B10_REG_DIGITAL_GAIN is left in the long sequence and rewritten here.
If OS05B10_REG_DIGITAL_GAIN_SHORT control is just not needed, please
remove it from the long sequence in advance, and then this change will
touch the remaining OS05B10_REG_DIGITAL_GAIN control only.
> + break;
> case V4L2_CID_EXPOSURE:
> ret = cci_write(os05b10->cci, OS05B10_REG_EXPOSURE,
> ctrl->val, NULL);
> @@ -925,7 +928,7 @@ static int os05b10_init_controls(struct os05b10 *os05b10)
> int ret;
>
> ctrl_hdlr = &os05b10->handler;
> - v4l2_ctrl_handler_init(ctrl_hdlr, 8);
> + v4l2_ctrl_handler_init(ctrl_hdlr, 9);
>
> pixel_rate = os05b10_pixel_rate(os05b10, mode);
> v4l2_ctrl_new_std(ctrl_hdlr, &os05b10_ctrl_ops, V4L2_CID_PIXEL_RATE,
> @@ -967,6 +970,10 @@ static int os05b10_init_controls(struct os05b10 *os05b10)
> OS05B10_ANALOG_GAIN_STEP,
> OS05B10_ANALOG_GAIN_DEFAULT);
>
> + v4l2_ctrl_new_std(ctrl_hdlr, &os05b10_ctrl_ops, V4L2_CID_DIGITAL_GAIN,
> + OS05B10_DIGITAL_GAIN_MIN, OS05B10_DIGITAL_GAIN_MAX,
> + OS05B10_DIGITAL_GAIN_STEP, OS05B10_DIGITAL_GAIN_DEFAULT);
> +
> if (ctrl_hdlr->error) {
> ret = ctrl_hdlr->error;
> dev_err(os05b10->dev, "control init failed (%d)\n", ret);
--
Best wishes,
Vladimir
next prev parent reply other threads:[~2026-07-24 13:19 UTC|newest]
Thread overview: 51+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-07-18 20:08 [PATCH v3 00/17] media: i2c: os05b10: Refactor driver and Add new features Tarang Raval
2026-07-18 20:08 ` [PATCH v3 01/17] media: i2c: os05b10: Use pm_runtime_get_if_active() when applying controls Tarang Raval
2026-07-22 5:58 ` Jai Luthra
2026-07-24 6:47 ` Tarang Raval
2026-07-18 20:08 ` [PATCH v3 02/17] media: i2c: os05b10: drop unused group-hold programming Tarang Raval
2026-07-18 20:08 ` [PATCH v3 03/17] media: i2c: os05b10: add register definitions and use them in init table Tarang Raval
2026-07-21 17:25 ` Mehdi Djait
2026-07-24 13:09 ` Vladimir Zapolskiy
2026-07-18 20:08 ` [PATCH v3 04/17] media: i2c: os05b10: split common and mode-specific init registers Tarang Raval
2026-07-21 17:40 ` Mehdi Djait
2026-07-24 13:15 ` Vladimir Zapolskiy
2026-07-18 20:08 ` [PATCH v3 05/17] media: i2c: os05b10: add V4L2 digital gain control Tarang Raval
2026-07-24 13:19 ` Vladimir Zapolskiy [this message]
2026-07-24 14:15 ` Tarang Raval
2026-07-18 20:08 ` [PATCH v3 06/17] media: i2c: os05b10: Add H/V flip support Tarang Raval
2026-07-21 17:43 ` Mehdi Djait
2026-07-22 5:51 ` Jai Luthra
2026-07-24 7:01 ` Tarang Raval
2026-07-24 13:27 ` Vladimir Zapolskiy
2026-07-18 20:08 ` [PATCH v3 07/17] media: i2c: os05b10: Add test pattern options Tarang Raval
2026-07-21 17:50 ` Mehdi Djait
2026-07-24 13:43 ` Vladimir Zapolskiy
2026-07-18 20:08 ` [PATCH v3 08/17] media: i2c: os05b10: add 12-bit RAW mode support Tarang Raval
2026-07-24 14:08 ` Vladimir Zapolskiy
2026-07-24 14:30 ` Tarang Raval
2026-07-24 15:03 ` Vladimir Zapolskiy
2026-07-18 20:09 ` [PATCH v3 09/17] media: i2c: os05b10: update pixel rate on 10/12-bit mode switch Tarang Raval
2026-07-22 6:17 ` Jai Luthra
2026-07-22 6:19 ` Jai Luthra
2026-07-24 9:08 ` Tarang Raval
2026-07-25 7:26 ` Vladimir Zapolskiy
2026-07-18 20:09 ` [PATCH v3 10/17] media: i2c: os05b10: Add 1080p and 2x2 binning 720p modes Tarang Raval
2026-07-22 6:05 ` Jai Luthra
2026-07-24 6:44 ` Tarang Raval
2026-07-18 20:09 ` [PATCH v3 11/17] media: i2c: os05b10: keep vblank and exposure range in sync on mode switch Tarang Raval
2026-07-25 7:30 ` Vladimir Zapolskiy
2026-07-18 20:09 ` [PATCH v3 12/17] media: i2c: os05b10: Update active format before adjusting framing controls Tarang Raval
2026-07-25 7:32 ` Vladimir Zapolskiy
2026-07-18 20:09 ` [PATCH v3 13/17] media: i2c: os05b10: Rename vmax variable in VBLANK control Tarang Raval
2026-07-25 7:33 ` Vladimir Zapolskiy
2026-07-18 20:09 ` [PATCH v3 14/17] media: i2c: os05b10: add 2-lane support Tarang Raval
2026-07-25 7:38 ` Vladimir Zapolskiy
2026-07-18 20:09 ` [PATCH v3 15/17] media: i2c: os05b10: fix negative hblank calculation Tarang Raval
2026-07-22 6:14 ` Jai Luthra
2026-07-24 8:14 ` Tarang Raval
2026-07-18 20:09 ` [PATCH v3 16/17] media: i2c: os05b10: Enable runtime PM autosuspend Tarang Raval
2026-07-22 6:08 ` Jai Luthra
2026-07-24 7:02 ` Tarang Raval
2026-07-24 9:58 ` Jai Luthra
2026-07-18 20:09 ` [PATCH v3 17/17] media: i2c: os05b10: remove unused control fields, simplify error handling Tarang Raval
2026-07-25 11:33 ` Vladimir Zapolskiy
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=fb9b5132-e5b6-405f-b930-8d2b44c3740c@linaro.org \
--to=vladimir.zapolskiy@linaro.org \
--cc=elgin.perumbilly@siliconsignals.io \
--cc=himanshu.bhavani@siliconsignals.io \
--cc=hverkuil+cisco@kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=mchehab@kernel.org \
--cc=mehdi.djait@linux.intel.com \
--cc=sakari.ailus@linux.intel.com \
--cc=tarang.raval@siliconsignals.io \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®