From: xiong <xiong@qca.qualcomm.com>
To: <davem@davemloft.net>, <netdev@vger.kernel.org>,
<linux-kernel@vger.kernel.org>
Cc: <qca-linux-team@qualcomm.com>, <nic-devel@qualcomm.com>,
xiong <xiong@qca.qualcomm.com>
Subject: [PATCH 07/37] atl1c: remove code related to rxq 1/2/3
Date: Fri, 13 Apr 2012 08:14:32 +0800 [thread overview]
Message-ID: <1334276102-15866-8-git-send-email-xiong@qca.qualcomm.com> (raw)
In-Reply-To: <1334276102-15866-1-git-send-email-xiong@qca.qualcomm.com>
remove code related to rxq 1/2/3 since multi-q not support.
refine REG_RXQ_CTRL definition as well.
Signed-off-by: xiong <xiong@qca.qualcomm.com>
Tested-by: Liu David <dwliu@qca.qualcomm.com>
---
drivers/net/ethernet/atheros/atl1c/atl1c_hw.h | 29 +++++++++-------------
drivers/net/ethernet/atheros/atl1c/atl1c_main.c | 3 +-
2 files changed, 13 insertions(+), 19 deletions(-)
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h b/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
index ca45fad..18c1f18 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_hw.h
@@ -493,26 +493,21 @@ int atl1c_phy_power_saving(struct atl1c_hw *hw);
#define ASPM_THRUPUT_LIMIT_NO 0x00
#define ASPM_THRUPUT_LIMIT_1M 0x01
#define ASPM_THRUPUT_LIMIT_10M 0x02
-#define ASPM_THRUPUT_LIMIT_100M 0x04
-#define RXQ1_CTRL_EN 0x10
-#define RXQ2_CTRL_EN 0x20
-#define RXQ3_CTRL_EN 0x40
-#define IPV6_CHKSUM_CTRL_EN 0x80
-#define RSS_HASH_BITS_MASK 0x00FF
-#define RSS_HASH_BITS_SHIFT 8
-#define RSS_HASH_IPV4 0x10000
-#define RSS_HASH_IPV4_TCP 0x20000
-#define RSS_HASH_IPV6 0x40000
-#define RSS_HASH_IPV6_TCP 0x80000
+#define ASPM_THRUPUT_LIMIT_100M 0x03
+#define IPV6_CHKSUM_CTRL_EN BIT(7)
#define RXQ_RFD_BURST_NUM_MASK 0x003F
#define RXQ_RFD_BURST_NUM_SHIFT 20
-#define RSS_MODE_MASK 0x0003
+#define RXQ_NUM_RFD_PREF_DEF 8
+#define RSS_MODE_MASK 3UL
#define RSS_MODE_SHIFT 26
-#define RSS_NIP_QUEUE_SEL_MASK 0x1
-#define RSS_NIP_QUEUE_SEL_SHIFT 28
-#define RRS_HASH_CTRL_EN 0x20000000
-#define RX_CUT_THRU_EN 0x40000000
-#define RXQ_CTRL_EN 0x80000000
+#define RSS_MODE_DIS 0
+#define RSS_MODE_SQSI 1
+#define RSS_MODE_MQSI 2
+#define RSS_MODE_MQMI 3
+#define RSS_NIP_QUEUE_SEL BIT(28) /* 0:q0, 1:table */
+#define RRS_HASH_CTRL_EN BIT(29)
+#define RX_CUT_THRU_EN BIT(30)
+#define RXQ_CTRL_EN BIT(31)
#define REG_RFD_FREE_THRESH 0x15A4
#define RFD_FREE_THRESH_MASK 0x003F
diff --git a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
index c7d7640..ca1259d 100644
--- a/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
+++ b/drivers/net/ethernet/atheros/atl1c/atl1c_main.c
@@ -1137,8 +1137,7 @@ static int atl1c_stop_mac(struct atl1c_hw *hw)
u32 data;
AT_READ_REG(hw, REG_RXQ_CTRL, &data);
- data &= ~(RXQ1_CTRL_EN | RXQ2_CTRL_EN |
- RXQ3_CTRL_EN | RXQ_CTRL_EN);
+ data &= ~RXQ_CTRL_EN;
AT_WRITE_REG(hw, REG_RXQ_CTRL, data);
AT_READ_REG(hw, REG_TXQ_CTRL, &data);
--
1.7.7
next prev parent reply other threads:[~2012-04-13 0:16 UTC|newest]
Thread overview: 45+ messages / expand[flat|nested] mbox.gz Atom feed top
2012-04-13 0:14 [PATCH 00/37] atl1c: update hardware settings xiong
2012-04-13 0:14 ` [PATCH 01/37] atl1c: update author contact info & company/driver desciption xiong
2012-04-13 0:14 ` [PATCH 02/37] atl1c: remove multiple-RX-Q code xiong
2012-04-13 0:14 ` [PATCH 03/37] atl1c: remove HDS register xiong
2012-04-13 0:14 ` [PATCH 04/37] atl1c: remove VPD register xiong
2012-04-14 0:45 ` David Miller
2012-04-14 9:12 ` Huang, Xiong
2012-04-14 14:22 ` Ben Hutchings
2012-04-14 18:24 ` David Miller
2012-04-17 8:36 ` Huang, Xiong
2012-04-13 0:14 ` [PATCH 05/37] atl1c: remove SMB/CMB DMA related code xiong
2012-04-13 0:14 ` [PATCH 06/37] atl1c: split 2 32bit registers of TPD to 4 16bit registers xiong
2012-04-13 0:14 ` xiong [this message]
2012-04-13 0:14 ` [PATCH 08/37] atl1c: wrong register used to stop TXQ xiong
2012-04-13 0:14 ` [PATCH 09/37] atl1c: correct wrong definition of REG_DMA_CTRL xiong
2012-04-13 0:14 ` [PATCH 10/37] atl1c: remove dmaw_block xiong
2012-04-13 0:14 ` [PATCH 11/37] atl1c: using fixed TXQ configuration for l2cb and l1c xiong
2012-04-13 0:14 ` [PATCH 12/37] atl1c: restore max-read-request-size in Device Conrol Register xiong
2012-04-13 17:02 ` Ben Hutchings
2012-04-14 10:39 ` Huang, Xiong
2012-04-13 0:14 ` [PATCH 13/37] atl1c: threshold for ASPM is changed based on chip capability xiong
2012-04-13 0:14 ` [PATCH 14/37] atl1c: add module parameter for l1c_wait_until_idle xiong
2012-04-13 0:14 ` [PATCH 15/37] atl1c: update right threshold for TSO xiong
2012-04-13 0:14 ` [PATCH 16/37] atl1c: remove dmar_dly_cnt and dmaw_dly_cnt xiong
2012-04-13 0:14 ` [PATCH 17/37] atl1c: clear PCIE error status in atl1c_reset_pcie xiong
2012-04-13 0:14 ` [PATCH 18/37] atl1c: refine reg definition of REG_MASTER_CTRL xiong
2012-04-13 0:14 ` [PATCH 19/37] atl1c: clear bit MASTER_CTRL_CLK_SEL_DIS in atl1c_pcie_patch xiong
2012-04-13 0:14 ` [PATCH 20/37] atl1c: refine/update ASPM configuration xiong
2012-04-13 0:14 ` [PATCH 21/37] atl1c: refine atl1c_pcie_patch xiong
2012-04-13 0:14 ` [PATCH 22/37] atl1c: fix WoL(magic) issue for l2cb 1.1 xiong
2012-04-13 0:14 ` [PATCH 23/37] atl1c: remove MDIO_REG_ADDR_MASK in atl1c_mdio_read/write xiong
2012-04-13 0:14 ` [PATCH 24/37] atl1c: remove REG_PHY_STATUS xiong
2012-04-13 0:14 ` [PATCH 25/37] atl1c: refine phy-register read/write function xiong
2012-04-13 0:14 ` [PATCH 26/37] atl1c: remove PHY contrl in atl1c_reset_pcie xiong
2012-04-13 0:14 ` [PATCH 27/37] atl1c: refine SERDES-clock related code xiong
2012-04-13 0:14 ` [PATCH 28/37] atl1c: remove PHY polling from atl1c_open xiong
2012-04-13 0:14 ` [PATCH 29/37] atl1c: update PHY reset related routine xiong
2012-04-13 0:14 ` [PATCH 30/37] atl1c: remove PHY reset/init for link down event xiong
2012-04-13 0:14 ` [PATCH 31/37] atl1c: add function atl1c_power_saving xiong
2012-04-13 0:14 ` [PATCH 32/37] atl1c: refine start/enable code for MAC module xiong
2012-04-13 0:14 ` [PATCH 33/37] atl1c: add PHY link event(up/down) patch xiong
2012-04-13 0:14 ` [PATCH 34/37] atl1c: clear WoL status when reset pcie xiong
2012-04-13 0:15 ` [PATCH 35/37] atl1c: remove code of closing register writable attribution xiong
2012-04-13 0:15 ` [PATCH 36/37] atl1c: refine mac address related code xiong
2012-04-13 0:15 ` [PATCH 37/37] atl1c: cancel task when interface closed xiong
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=1334276102-15866-8-git-send-email-xiong@qca.qualcomm.com \
--to=xiong@qca.qualcomm.com \
--cc=davem@davemloft.net \
--cc=linux-kernel@vger.kernel.org \
--cc=netdev@vger.kernel.org \
--cc=nic-devel@qualcomm.com \
--cc=qca-linux-team@qualcomm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®